Overview
PreForm is Formlabs' print-preparation software for the Form 3L. It converts a model into an SLA build with orientation, supports, layer settings, material selection, and printer-specific processing.
CAD -> STL/3MF -> PreForm -> Form 3L -> Wash -> Dry -> Cure
Basic Workflow
- Import the model into PreForm.
- Select Form 3L as the printer.
- Select the resin actually installed in the printer.
- Select the required layer height.
- Orient the model.
- Generate and inspect supports.
- Check printability and build-platform placement.
- Send/upload the job to the Form 3L using the configured workflow.
- Save the project/settings with research data when reproducibility matters.
Orientation
SLA orientation influences:
- Peel/separation forces
- Support requirements
- Surface finish
- Dimensional accuracy
- Resin trapped in cavities
- Print time
Avoid treating "flat on the platform" as the universal best orientation. Large cross-sectional areas can create unfavorable printing forces and surface artifacts.
Supports
Automatic support generation is a good starting point, not a substitute for inspection.
Review:
- Unsupported islands
- Critical cosmetic surfaces
- Small features
- Contact-point locations
- Long or flexible features
- Internal supports that may be impossible to remove
Place support marks away from critical mating or cosmetic surfaces when practical.
Hollow Parts and Drainage
Large solid SLA models can consume substantial resin. Hollowing can reduce resin usage, but cavities need suitable drainage/venting.
A sealed cavity containing uncured resin is a quality and safety problem. Design drain holes so uncured resin and wash fluid can actually leave the part.
Resin Selection
Select the exact Formlabs material/profile installed in the printer. Resin chemistry determines not only printing parameters but also post-processing requirements.
Do not copy wash/cure conditions from another material simply because both print successfully on the Form 3L.
Layer Height
Choose layer height based on required detail, geometry, material support, and throughput. Finer layers may improve some surface/detail characteristics but increase build time.
Post-Processing Is Part of the Process
After printing:
- Drain excess resin appropriately.
- Remove the part from the build platform.
- Wash in the lab's manual wash bath according to the resin's specified procedure.
- Allow solvent to evaporate and the part to dry completely.
- Remove supports at the appropriate process stage.
- Cure in the large curing station using that resin's specified time and temperature.
For mechanical specimens, record wash and cure parameters with the print parameters because they affect measured material behavior.
File and Experiment Records
Preserve:
- Original CAD/revision
- PreForm project when applicable
- Resin/revision/lot
- Layer height
- Orientation
- Support configuration
- Wash procedure
- Cure procedure
This makes the manufactured state traceable rather than treating the STL as the entire experiment definition.